QUICSEAL 109CP

Horizontal surface

For waterproofing of slightly sloped surfaces, the installation must start from the lowest point and the overlapping must be formed in order to shed water.

Vertical surface

It recommended that the membrane be installed in lengths of 2.5m to 3m. If the surface to be covered exceeds this height, install QUICSEAL 109cp in several stages, starting from the lowest point and overlapping the joint by 50mm. Where QUICSEAL 109cp is to be left temporarily exposed on vertical faces, the membrane may be fixed with batten at the edge to prevent slippage. Remove battening prior to backfilling and cover fully with subsequent layer of QUICSEAL 109cp. Unroll membrane and position it on the prepared surface and pull off the release paper.  Upon proper alignment, press the membrane into position. Any punctures or damaged areas should be cleaned and patched using QUICSEAL 109 with 50mm laps all round.

Packaging

Pack size : 1m x 20m per roll